Seta Oxi-Cor Bath – 15550-3
The Seta Oxi-Cor bath is a stainless steel water or oil bath. Temperature controlled by a top mounted thermostir circulator with integral over-temperature and low fluid level protection devices.
The bath has four test stations. Each has a lid with a hook, from which you suspend either a Corrosion Pressure Vessel (11500-0) or a test tube Support Assembly (11420-0), holding up to three Test Tubes (11590-0). You can use any combination of these.
NOTE: For oxidation tests, methods specify a certain bath volume per pressure vessel. In order to comply with this, you can only use two oxidation pressure vessels in the bath at the same time.
Seta Oxi-Cor Bath – 15550-3
specifications
TEMPERATURE RANGE | Ambient +5 °C to 150 °C |
---|---|
TEMPERATURE STABILITY | ±0.1 °C |
BATH CAPACITY | 34 litres |
HEATER POWER | 1500 W |
VOLTAGE | 110/120 V, 50/60 Hz 220/240 V, 50/60 Hz |
SIZE (HXWXD) | 520 × 485 × 330 mm |
WEIGHT | 10 kg |
CCCN CODE | Tariff 84198998 |
Manufacturers
show DATA — DO NOT CHANGE ID–
Industries
show DATA — DO NOT CHANGE ID–
Methods
show DATA — DO NOT CHANGE ID–
Spares and accessories for 15550-3
Oxidation Vessel – 15802-2
Thin Silver Strip Corrosion Kit – 11516-0
This Stanhope-Seta kit comprises all of the accessories required to carry out tests on gasoline to the ASTM D7667 standard. Supplies allow for running two tests simultaneously.
Copper Corrosion Kit for Diesel, Fuel Oil and Lubricants – 11518-0
Copper Corrosion Kit for Gasoline and Jet Fuel – 11517-0